Soft film anti Rust remover P5
Application：Soft film anti-rust oil P5 is a low viscosity thin layer anti-rust agent, refined from mineral base oil, a variety of special anti-rust additives and solvents. It leaves a uniform anti-rust film after being applied to the metal surface. It is widely used for long-term anti-rust protection of steel, with low dosage, strong adhesion, and super clear anti-rust and anti-corrosion performance.
Product Introduction
Soft film anti Rust remover P5
Performance advantages:
1. Strong permeability: The soft film rust inhibitor has low viscosity. After being applied to the metal surface, the solvent will transport the lubricating oil and fatty acid additives to the gaps and rusted areas, leaving a layer of lubricant film on the metal surface before evaporating, preventing wear on the friction surface. Fatty oil has good rust resistance and can prevent new rust.
2. Long anti-rust period: Leave a thin non-drying film with extremely strong protective performance on the metal surface. The film has good water displacement ability and can effectively resist the chemical erosion of air, water and other liquid and solid particulate matter.
3. Low cost: Due to low viscosity, thin oil film and small amount of use, 40-50m3 can be applied per liter, the unit cost is low, and the oil film has extremely strong self-sealing properties. Even if it is scratched or brushed, there is no need to repair the protective film, and the total cost is low.
4. Easy to clean: The oil film formed on the metal surface can be easily washed clean with petroleum solvent or kerosene.
5. Eliminate noise: It can make the lubricant penetrate into small spaces and form an oil film, thereby reducing the wear between moving parts and eliminating noise.
Main Application:
Soft Film Antirust Agent is widely used for rust-proof treatment of various types of steel, hardware parts, mechanical products and other metals;
Precautions:
1. Before applying oil, the metal must be cleaned and there must be no dirt and moisture on the surface, otherwise it will affect the effect.
2. You can use dipping, spraying, brushing, painting, etc. The metal surface must be oiled. Wear gloves when applying oil.
Typical data:
project | parameters |
Appearance | yellow transparent |
Process requirements | Thin oil film |
Main component | Mineral oil, solvent, water |
Artifact type | Precision parts |
Oil film requirements | Semi-dry solvent type |
Anti-rust period (months) | 12 |
Flash point (℃) | >70 |
Salt spray test 45# steel, hours | ≥24 |
How to use | Dip, spray, roller brush |